| WLL170红色LED发射器，适合标准应用场合 手动灵敏度调校 简单的安装和对准 机架兼备发送器和接受器。 两条纤维光缆，适用扫描或光束透过原理 SICK WLL170-2N132 Overview Photoelectric fiber optic switch WLL170-2N132 SICK WLL170-2N132 De Sender LED red for standard applications Manual sensitivity setting Simple installation and alignment Product features Sensing range min ... max (through-beam system): 0 ... 4,000 mm Fibre-optic cable (through-beam system): LL3-TB02 and tip adapter LL3-TA01 Sensing range min ... max (proximity system): 0 ... 160 mm Fibre-optic cable (proximity system): LL3-DK06 Adjustment: Potentiometer, 10 revolutions Light source: LED Type of light: Red light Wave length: 660 nm Light spot diameter: depending on the scanning range Technical data Design: cuboid Dimensions (W x H x D): 10.5 x 35.5 x 79.9 mm Angle of dispersion: ca. 65 ° Supply voltage min ... max: DC 10 ... 30 V Ripple: 10 % Power consumption: <= 30 mA Switching output: NPN: open collector: Q Switching mode: Light-/dark-switching, switchable Output current max.: <= 100 mA Response time: <= 0.25 ms Switching frequency: 2,000 Hz Time delay: 40 ms fix, selectable by sliding switch Time type: Off delay tOFF Connection type: cable, 2 m Cable material: PVC Cable diameter: O 3.8 mm Number of cores: 3 Conductor cross section: 0.2 mm2 Circuit protection: Vs connections reverse-polarity protected / In-/outputs short-circuit protected / Interference suppression / Outputs overcurrent and short-circuit protected Enclosure rating: IP 66 Ambient operation temperature, min ... max: -25 °C ... +55 °C Ambient storage temperature, min ... max: -40 °C ... +70 °C Weight: ca. 70 g Front screen heating: - Polarisation filter: - Housing material: ABS/PC |
